Special 3/16" dia. bolt with drilled shank. With hex nuts and washers. Use instead of "bug" nut.
Q+A
How is this Bolt Type Terminal used? Also, what are the dimensions?
It is used to connect a solid wire to an actuator arm, similar to a throttle arm on a carburator. The bolt is a special drilled AN3-4, which is 3/16" diameter, and 17/32" long. You would slide the bolt through the arm hole, slide the solid wire through the drilled hole in the bolt, and tighten the nut supplied to secure the solid wire at that location on the arm.
Unit
EA
Hazardous
No
Oversize
No
Weight
0.014 kg
This part is included in the following categories: